Forum Discussions (4,426)
| Discussions | Replies | Latest Activity |
|---|---|---|
EM-150 wiringDoes anybody have a factory schematic for a 1954 Gibson EM-150 mandolin? Started by Bob Gaddis in Luthier Talk |
6 |
May 4, 2013 Reply by Bob Gaddis |
1950's EM 150 truss rod replacement & binding.I am finally getting back into repairing this EM-150 that had been sat upon. The neck is cracked and had a ski-slope bow in it. The end of… Started by Bob Gaddis in Luthier Talk |
2 |
May 3, 2013 Reply by Bob Gaddis |
12-string top warps and bumps, possible collapse?I got a 12-string Ibanez acoustic today with an initial complaint of high action. After some measurements I knew that the truss rod was loo… Started by tadej bratkovic in Luthier Talk |
3 |
May 3, 2013 Reply by Mark McLean |
doubleneck wiringHello all, i have an sg doubleneck in the shop that i need to wire up but can`t find a diagram other than gibsons schematic for a 1275.i al… Started by graham high in Luthier Talk |
11 |
May 1, 2013 Reply by Paul Young |
a couple of lil' things....(hmmm, I s'pose it's OK to bring up 2 topics in one discussion?.... at any rate..... (1). I see where StewMac just released a new version… Started by Mike Kolb in Luthier Talk |
10 |
May 1, 2013 Reply by Mark A. Kane |
Taylor 110 CE Intonation IssueHey everyone. I set up two guitars for my friend, a Japan Strat (really nice guitar too) and a Taylor 110 CE. Everything has gone just fine… Started by David Edward Helmer in Luthier Talk |
1 |
Apr 30, 2013 Reply by Paul Verticchio |
Broken Truss Rod on a Fender Squier Stagemaster (Stratocaster)This is my first post here and sorry it's long but I will try to cut to the chase: I have a Squier Stagemaster (Stratocaster) with rosewoo… Started by Paul Young in Luthier Talk |
5 |
Apr 29, 2013 Reply by Paul Verticchio |
ADVICE PLEASE..RE BROKEN REMOVING BROKEN SCREW IN WAVERLY F MANDO TUNERplease see attached photo.. i believe the best way to get the sheared screw remains out from inside the threaded shaft is to take the s… Started by Tony in Metalworking, Machining, Tool & Fixture Making for Luthiers |
18 |
Apr 28, 2013 Reply by Tony |
Sticky Varathane Issue on NeckI had to refinish a guitar neck and decided to try using Varathane. It is a spray stain/urathane availabe a big box home stores. I put ligh… Started by Matt Haugen in Luthier Talk |
3 |
Apr 28, 2013 Reply by Paul Young |
srinking side binding on a 1935 Epiphone guitarI have a 1935 Epiphone guitar with sringing binding at the waist. Any good ideas to fix that? Ihad one that I used a heat gun and got it… Started by Ron Frazier in Luthier Talk |
7 |
Apr 28, 2013 Reply by David Collins |
© 2026 Created by Frank Ford.
Powered by
